How to Replace the Microswitch on the Eccotemp L7
Updated over a week ago

How to replace the microswitch on your Eccotemp L7 Portable Tankless Water Heater

  1. Remove the cover via the 2 screws located at the BOTTOM of the unit. (2 screws total)

  2. Gently remove the cover by sliding the cover up towards the top and mind the wires and the on/off switch.

  3. The Microswitch is located in the center of the Gas/Water Valve assembly and held on by 2 screws. Unscrew the 2 screws and set screws aside in a safe place.

  4. Disconnect the Microswitch from the Solenoid.

  5. Connect the new Microswitch to the solenoid and use the 2 screws to screw back into its original place.

  6. After making sure your batteries are new and in place, pull the small metal lever on the side of the microswitch to ensure it clicks. *Note, the unit must be upright.

Did this answer your question?