Skip to main content
Draining your SH12
Updated over a week ago

Draining Your Water Heater

To Drain your water heater, follow these steps:

  1. Make sure the SH12 is powered down.

  2. Turn the incoming flow for hot and cold water to the off position on the respective valves located on the water lines.

  3. Flip the pressure relief valve to the open position. It should extend perpendicular from the pipes when open.

  4. Disconnect hot and cold water connections from the SH12.

  5. Allow ample time for the SH12 to drain

NOTE: After draining, a small amount of water may still remain inside the SH12.

mceclip1.png
Did this answer your question?